 鲜花( 6)  鸡蛋( 0)
|
本帖最后由 craigliu 于 2011-3-13 12:10 编辑 1 z; s: N% |0 h# F' `
7 l! S; B7 F' B( b
"打算把这个硬盘拆下来连到另一台电脑上,可是怎么才能连上呢?".
/ O8 F' d- K! m8 G7 p% Z% H/ H6 u1) Open case, you usually need to open two sides. ) m6 P2 r# U7 N+ A" S% d
2) unplug cables that attached to the HD. Usually there are two cables (one for power, one for data).
* n1 u9 N& n' M3) unscrew for HD.- i( I5 {0 ^# O4 U! P u
4) take out HD.' C! `& k3 U0 R1 {
5) Usually The HD is set as Master, and you need to reset jumper pin into Slave. There is a label on the HD that indicators how you set jumper pin. - D0 @; r5 C5 A2 k
6) open the case of another computer.# q9 r& t) Z! r
7) Connect all cables. (two cables. Only correct cable can be plugged. So just try, if you can plug in, it is right cable.)
$ I- A p4 \% z% U* o- T9 B, x) Z1 r8) start computer.8 `, I& v2 @0 G4 o
6 Y' t) g- V4 s/ J* X
(I suppose you use the HD that was popular before, because you use XP.) |
|