 鲜花( 7)  鸡蛋( 0)
|
How to avoid too much chips left in panel box after your drill a hole ?" X8 \7 X. |8 Q+ c e
$ L+ g) w$ `3 C4 y0 }6 Z0 S1. If you are going to drill a hole on top of a box, use some paper to cover the bottom of the box so that you can easily remove the paper with chips in it; . l1 M2 [: r1 I3 i' X# F
2. Make sure you cover all equipments (breakers, contacts, relays, fuses, Etc)in the box before you drill holes;. A8 ^6 B3 d, U% h/ P! d( r
3. Use a paint brush to collect all debris (one of the best tools that is always in my tool box), and clean it up before your get all connectors in;5 k& |9 c8 O- Q$ S* s8 ]# @
4. Use your level's magnetic side to collect all steel chips;
, t: c8 ~& A7 |. f6 |5. Use duct tape to get rid of all small chips;
; [: e; _, y- F0 h1 |8 l% ]6. Use a vacuum if you just have it beside you(a bit too luxury, but why not!).
) A& {7 l% p. d/ j: p2 |; l- c d- B5 b9 X% _2 P3 z! I
And another vital important point: DO NOT try to below those chips out! Most likely you will just below your mess everywhere, including your precious eyes.9 h! q8 c+ C% O/ f; l4 @0 Y
$ [9 G" s! K2 F2 l$ J. q: C# G# `( ?- t5 r
Donate a flower if your think this article is helpful. Welcome all reply, and add some of your secret!
: Z, }) a/ ]1 \+ g+ q1 M) p6 q; j& K8 f* M! H' |+ z, O
[ 本帖最后由 homestay 于 2009-3-14 19:32 编辑 ] |
|