 鲜花( 0)  鸡蛋( 0)
|
this is what code says:. ~6 F" Z3 \: m9 x
4-028: Identification of insulated neutral conductors up to and including No. 2 AWG
0 T, X/ s" @7 O5 @' ccopper or aluminum. M6 L9 l) L; _; G: `4 J
(1) Except as permitted in Subrules (2), (3), and (4), all insulated neutral conductors up to and including
2 ]+ B/ |( w, o/ D" iNo. 2 AWG copper or aluminum, and the conductors of flexible cords that are permanently connected to
8 j- o/ t9 c2 |' L3 d/ zsuch neutral conductors, shall be identified by a white or grey covering or by three continuous white stripes* ~. o' }% f8 `+ K v4 T6 _
along the entire length of the conductor.# f9 m* [, c. K
(2) Where conductors of different systems are installed in the same raceway, box, or other type of enclosure1 |5 d' W% b; O1 s$ y
and the identified circuit conductor of one system is coloured by a white or grey covering, each identified
; ^8 }+ @* K$ tcircuit conductor of the other system, if present, shall be provided with a specific identification, and the% D4 H1 }. b' k, t$ ]% K( X4 w" H% h
identification shall be permitted to be an outer covering of white with an identifiable coloured stripe (not
4 k# G* i: ]: O1 z& i5 n+ y- Z0 Jgreen) running along the insulation.
5 r8 O0 `7 F' g( n3 C6 l; H(3) The covering of the other conductor or conductors shall show a continuous colour contrasting that of# J3 D5 q8 q" q j
an identified conductor; however, in the case of those flexible cords where the identified conductor is
2 e4 \8 U J0 j4 U( ?3 u( c9 Bidentified by a raised longitudinal ridge(s), the other conductors shall have no ridges./ g1 \2 e8 G$ ^% V0 g$ s" J
(4) For multi-conductor cable, the insulated neutral conductor shall be permitted to be permanently marked
- `' m1 v w# k; D1 @* J* V" das the identified conductor by painting or other suitable means at every point where the separate# h5 g% \3 ^# S+ B5 ^
conductors have been rendered accessible and visible by removal of the outer covering of the cable, and: G$ S$ t' W, N4 p. G7 k0 |* e
the painting or other suitable means of marking the identified conductor shall not be permitted to render6 {* O3 t3 b0 D' X% y
illegible the manufacturer’s numbering of the conductor. |
|