本帖最后由 冥顽脑袋 于 2014-9-23 07:19 编辑 0 F3 E4 l' I, s0 |( c+ f 5 t% B, ^$ F; O' d) s% f+ a" V/ U; u' c换卡可能用不了原号码了。 K+ Q* Z ?. O9 Z: U : L/ N( `; @2 h剪卡可以参考如下,打印出来做模板。 & e8 O) W/ r# \) Tnanosimltr.pdf - Cutting guide for Letter sized paper " V* z* v8 R f! |! Gnanosima4.pdf - Cutting guide for A4 sized paper0 G. `: c3 ^/ W% h
6 K/ y5 U6 c5 u- S) w; [Mini/MicroSIM to NanoSIM cutting guide 8 a+ G& H6 K! m * h1 Y+ \: J. j7 D5 fEquipment: - L8 W2 n$ r" ?' |- H# \7 C6 w- Ruler* D( W. F% l1 j" W
- Tape " A! u4 h4 D" E& a: X$ Z+ c6 g! o- Good quality scissors (test on old credit card)7 H8 `: \# C7 m. v% I
- Nail file or sand paper (220 grit or higher) 3 I) H8 J# |0 a* o' `4 M- Permanent felt tip marker pen8 x( {5 Q' I6 W+ x8 w! w
Instructions:- I2 \( J# ^& m% c H
1. Measure side rulers on guide to ensure guide has been printed to the correct scale. / U3 ?4 J6 l; E1 ^4 i6 `2. Tape SIM to matching center outline with gold contacts up. Place tape on edges so as to not cover Nano SIM area.. n# Q- l3 s( Y' c2 A( f3 N1 Y! O+ n
3. Align ruler to cut line so that the ruler covers the gold contacts and mark with permanent marker felt pen. Repeat for the 5 cut lines. * U( M! K# e2 W& N4. Remove SIM from this sheet and trim with scissors so that a portion of the marker lines are still visible. Use nail le or sand paper to trim so that no marker lines can be seen. Trim further and round corners with nail file or sandpaper until it ts in the iPhone 5 SIM tray. . @8 a+ ]+ E" @" w( H! ?1 m8 X" p1 P5. Sand or le plastic logo side of SIM so that it sits ush with the edge of SIM tray (0.67 mm). Hold SIM and rub against file or sand paper. DO NOT sand gold contact side.0 F5 A# |8 _. k/ ?- c2 A% ?' I# e
6. Finish by lightly sanding all edges.$ }* I- \" f4 U& T
/ m2 N {# N+ [8 yI take no responsibility to damage caused to the SIM or phone. It’s your own risk.! K( V5 S2 ~8 }* e$ k ]